Changing Brake Pads On A Bicycle
Introduction
Brake pads are an essential component of a bicycle's braking system. Over time, they wear out and need to be replaced. Changing brake pads on a bicycle is a simple process that can be done at home with the right tools and knowledge. In this article, we will guide you through the steps to change brake pads on a bicycle.
What You Will Need
Before you start, make sure you have the following tools:
- Hex wrenches
- Flathead screwdriver
- New brake pads
Step 1: Remove The Wheel
Start by removing the wheel that you want to change the brake pads on. Use a hex wrench to loosen the bolts on the side of the wheel opposite the chain. Lift the wheel out of the frame and set it aside.
Step 2: Remove The Old Brake Pads
Locate the brake pads and remove the retaining pin or bolt that holds them in place. Use a flathead screwdriver to gently pry the old brake pads out of their holder.
Step 3: Install The New Brake Pads
Insert the new brake pads into place, making sure they are facing the rim of the wheel. Reattach the retaining pin or bolt to hold the new brake pads in place.
Step 4: Adjust The Brake Pads
Use a hex wrench to adjust the position of the brake pads so that they are aligned with the rim of the wheel. Make sure the brake pads are not touching the tire or the spokes.
Step 5: Reinstall The Wheel
Place the wheel back into the frame and tighten the bolts with a hex wrench. Spin the wheel to make sure the brake pads are not rubbing against the rim.
Conclusion
Changing brake pads on a bicycle is a simple process that can be done at home with the right tools and knowledge. By following these steps, you can ensure that your bicycle's braking system is working effectively and safely. Remember to regularly check and replace your brake pads to maintain optimal performance.